Home
 
About
Project Cars
Schedule
Sponsors
Gear Ratio Calculator
Rally Stage Times
Photo Gallery
Honda Wheel Database
Home »
Gallery » Civic Rally Car » Subframe & Radius Rods

Subframe & Radius Rods


Fatboy Raceworks Rally Spec Subframe & Radius Rods

Our crossmember was based on a unit by Place Racing, but with a much stronger crossbar, and skidplate mounting tabs.  The radius
DSC00773.JPG
Bent Part
The original Place Racing design--not strong enough for rally, this one is bent pretty bad.
Cutting off original radius rod 'cups'
Original Place Racing mounts cut off.
DSC00777.JPG
Checking the angles.
Mounting tabs, cut out via plasma.  AN nuts, bolts, washers.
Approximate orientation
Mounting tabs to cross member.  Held in place with a 7/16" AN Airframe Bolt.
Attaching the mounting tabs to the crossmember
Needs to be in double shear, or as close to it as we can make it.
How the rod end mounts to the lower control arm.
Radius Rod Test Fit--Rod end should be mounted in double-shear, not single shear like this mockup.
Radius Rod Test Fitting
Radius Rod Installed
Crossmember installed looking down from engine compartment.
DSC00789.JPG
Currie Enterprises Johnny Joint
Imagine if a rod end and a bushing had a love child.
Self lubricating rod end.
Assembled Radius Rod
Swaged tube radius rod
Page 1 of 2
next »
Powered by Gallery v2.2